Any ideas on how to replace broken wheel studs without hammering on the axle or removing the axle? Know where to find a c-clamp type hydraulic, pneumatic or manual press which can be used on the car without removing the axle or damaging the bearings???
Broken wheel studs
Jan 24, 2006
2 Replies
Just use a hammer and punch to drive the old one out. You will not hurt the bearing. Use a lug nut with some washers behind it to draw in the new stud.
Hammer it out. Its a Toyota damn it, its indestructable, dont you listen to the advertisments?
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required