Latest threads in Chevrolet 4x4 Trucksshow only best voted threads
Subject | Author | Posted | Replies | |
---|---|---|---|---|
|
96 chevy blazer problems
i have a 96 blazer 4x4 with 4.3 v-6 vortec motor. the problem i have is when it is cold it acts like it is flooded and hard to star. when it is at normal operating temp. it will start fine. i have...
1
|
16 years ago
|
1 | |
|
93 S-10 Blazer Brake Warning Light?
Howdy folks. This truck has had the ABS system removed and the warning light for the ABS is lit but that's not my question. I replaced the master cylinder on this yesterday and while on a drive, the...
2
|
16 years ago
|
2 | |
|
Getting Electric Shift Out Of 4WD Manually?
Foolishly, I think, I opted for the electric 4WD shift mechanism instead of the floor-mounted hand mechanism. So many things have failed on this vehicle, that I have to think the electric shift's...
2
|
16 years ago
|
2 | |
|
Shift A solenoid location in 4L60E transmission
I need to replace the Shift A solenoid. It is supposed to be easy once the pan is dropped. My question is, where is it located and how do I tell it from the Shift B solenoid? I have a 96 Suburban...
3
|
16 years ago
|
3 | |
|
Chevy Trucks Suck
I bought one after owning a Ford and Chevy sucks. My Ford was way better. Faster, got 12 milesa to the gallon, and was more dependalbe. You guys that buy Chevys are fools and suckers. And I looked...
18
|
16 years ago
|
18 | |
|
Stuck Brake Caliper
I took my truck in to the garage today because I've been hearing a "scratching" or light grinding noise in the past week...even when I don't have the brake pedal pushed. They told me my rear calipers...
2
|
16 years ago
|
2 | |
|
'03 S10 ZR5 4.3 Stalling, hesitating, loss of power
I'm at my wits end on this one. I have a 2003 S10 zr5 with the Vortec 4.3l that for about 3 months now has been hesitating, stalling and has had an extreme loss of power. Sometimes I fear for my life...
8
|
16 years ago
|
8 | |
|
PING: Troy
Hey man, wanted to see how things were coming along with your DVD/NAV/ GPS install. Larry
—
|
16 years ago
|
— | |
|
Wiring schematic needed for 95 Jimmy W series MAP ground at ECU
Do any of you have a confirmed connector location at the ECU/VCM for the MAP sensor ground? According to my trusty Chilton¹s which lists 94-99s (and excluded 95 schematics), it says ?G19¹ which I...
1
|
16 years ago
|
1 | |
|
'Burb Towing Hitch Rusting Out
I got the "towing package" on my '98 K1500. It's rusting out *really* badly along all the welds. A few more points for GM quality, I guess. Anyhow.... what I'm thinking is wire brush the areas...
1
|
16 years ago
|
1 | |
|
1997 S-10 Blazer 4X4 Starter V-6
Anyone know why the starters for this model cost so much? Had an issue with the starter shorting out causing a drain on battery and alt. Turned out to be a pretty expensive problem to fix. Thanks for...
2
|
16 years ago
|
2 | |
|
1992 s10 trany problems
1992 chev s10 4x4 is putting trany fluid out the vent tube (trany seems to work well and does not slip)any ideas?
—
|
16 years ago
|
— | |
|
AC low pressure valve replacement
Can I replace the AC low pressure valve myself? It looks like a bicycle shrader valve. I heard there's a tool for replacing it under pressure? If this is not diy, how much should a reasonable shop...
5
|
16 years ago
|
5 | |
|
vibration at 60 mph on Silverado pickup
When driving my 2000 Silverado 2500 I get a vibration that only lasts a second between 60-65 mph. It happens only at acceleration and not on deceleration. I have tried to determine if the transmission...
4
|
16 years ago
|
4 | |
|
anyone have a line-in on cheap MAP sensors?
Good day, I just found out that my parts guy in selling a MAP sensor for my 95 4.3L Jimmy for $168 CDN! He usually gets things at a modest discount so I don¹t even want to know what these run at the...
3
|
16 years ago
|
3 |