Jeep and Willys (new and old)

  1. Home
  2. Jeep and Willys (new and old)
14215 Threads Posts
to

Worth reading in Jeep and Willys (new and old)

Where can I?

Does' anyone know where a good place is to buy the factory skid plates for my 95'' Cherokee Country. I never knew that...
0 comments posted 22yrs
posted by Two Jeep's Jimmie
0 comments posted 22yrs posted by Two Jeep's Jimmie

Re: Wrangler Sound System Install?

I agree about Crutchfield. I bought a Pioneer AM/FM CD from them and they threw in the wiring harness which would've be...
3 comments posted 22yrs
posted by elflan
3 comments posted 22yrs posted by elflan

Re: Weber Carb Revisited

>I don't know the Weber idle control. > >'Most' Idle controls I am familiar with just open the throttle butterfly >plat...
12 comments posted 22yrs
posted by tookie_nospam
12 comments posted 22yrs posted by tookie_nospam

Re: Ford 9inch read axle

I have not yet seen it, but was told by the owner it was a 9 inch. What is the easiest way to confirm it is a 9 inch? B...
8 comments posted 22yrs
posted by morrissey
8 comments posted 22yrs posted by morrissey

Re: Which tire?

> Just what do I do with the two good (but different) tires? got a trailer, ? sell them, give away,
2 comments posted 22yrs
posted by spam
2 comments posted 22yrs posted by spam

Re: Building LEAK-FREE on-board air systems - HOW???

Go to at least three wraps of (white) teflon tape, one is never enough. Only use teflon tape on threaded fittings, if y...
0 comments posted 22yrs
posted by tookie_nospam
0 comments posted 22yrs posted by tookie_nospam

Re: Differential case spreader?

Ah, why didn't you say so before??? The ZJ's with the aluminum D44 center section are famous for the bearing noise in t...
3 comments posted 22yrs
posted by pkeating
3 comments posted 22yrs posted by pkeating

Re: New locksets and old keys...

You have too much money and enjoy replacing your vinyl windows frequently? Cheers, Paul > Sounds absurd, I know, but I'v...
2 comments posted 22yrs
posted by pkeating
2 comments posted 22yrs posted by pkeating

Re: rear axle broke!! need info.

The shafts are the same size as D44 shafts, and something like 31 spline. Still stuck with the smaller carrier and C-cl...
4 comments posted 22yrs
posted by pkeating
4 comments posted 22yrs posted by pkeating

Re: 02 Wrangler Brake Rotor Fiasco

Yeah, IIRC, the rotors, and hub bearings changed in 99. The Cheaper, 99 and earlier rotors will work if you change to t...
2 comments posted 22yrs
posted by pkeating
2 comments posted 22yrs posted by pkeating

After market AC?

I have a 6 cyl manual 99 TJ and would like to have an AC system installed. The only point of reference I have is my fat...
5 comments posted 22yrs
posted by mokordo4u
5 comments posted 22yrs posted by mokordo4u

Re: OT, Motorcycling in Chernobyl

> > One of my friend's Dads was in the army in the 50's. He was marched out to a > nuclear test site while it was still...
0 comments posted 22yrs
posted by billhughes
0 comments posted 22yrs posted by billhughes

Re: how "tight" should the crankshaft be with new bearings?

"TranSurgeon" wrote > good rule of thumb is you should be able to hook your little finger over one > of the counterweig...
28 comments posted 22yrs
posted by violet-lightening-modified
28 comments posted 22yrs posted by violet-lightening-modified

Re: Best "tough looking" tires for highway

I just saw a review that said they weren't any good on soft sand and sunk easily with minimal throttle. Anybody have a...
3 comments posted 22yrs
posted by drink
3 comments posted 22yrs posted by drink

Re: M.Romain -- High Speed Misfire(?)

I would leaning more towards bad spark plugs, maybe the coil or brain box firing them. That's only thing that just shut...
5 comments posted 22yrs
posted by billhughes
5 comments posted 22yrs posted by billhughes