110 crossmember corrision

Hello i have a 87 110 land rover when i got it it only had three months mot.i had a good look over it and all seemed well then last week i removed the chequer plate covering the rear crossmember and found two holes where reflectors had once been near the jacking points .the mot is now due,i dont have a lot of money at the moment and was wondering if this would be an mot fail ?thanks

Reply to
yimmyyam
Loading thread data ...

In message , yimmyyam writes

If you put the chequer plate back on then no it should not fail !!!

But without the plate it should and rightly so.

Just don't go towing a trailer or even worse get involved in an off road recovery.

Reply to
Marc Draper

I am sure you should be able to find someone to weld them up for you - cheap enough!!!

Reply to
Vince

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.