1. Home
  2. Car Maintenance
  3. peugeot 206 headlights down

peugeot 206 headlights down

got a really bad problem I can't solve on a peugot 206 2001 Y reg. The low beam headlights don't work. High beam is fine. I replaced the headlight switch stalk off the steering wheel but no joy. Is there a single fuse that feeds these lights? or is it a relay? If so where is it? I've googled for ages on this but can't find any info. I keep reading about passenger side fuses but there is no passenger side fusebox in this car. There's a load of fuses below the steering wheel and box of them under the bonnet. Problem is, non of the fuses are numbered or labelled in any way, except for amperage. There are no diagrams or box layouts or or even a hint of what fuse is for what and there's nothing on the internet to help with this. I read that the Haynes manual is useless for this so don't want to waste any more money. I've tried hunting for a service manual but all I get is links that go to dead ends. Any advice to get these lights back on?

Reply to
tg
Loading thread data ...

uk.rec.cars.maintenance added.

Tim

Reply to
Tim Downie

(Assuming a 1.4 petrol? Ask again if you want me to check another variant, although they are probably the same.)

Autodata shows 3 fuseboxes; 1x under bonnet, 2x fascia. Headlight fuses are in "fascia 1" fuse box, so perhaps there is another one?

However, each lamp has its own fuse; low beams are F31 and F32, so if they are both out it's unlikely to be the fuses(s).

From the wiring diagram, it would seem there are no relays involved, so my best guess would be a connector failure between the light switch and the fuse box.

Pugs are notoriously difficult to do electrical fault finding on; it's almost like no two are ever the same, and none of them totally conform to documentation. Good luck!

Chris

Reply to
Chris Whelan

Have you checked the bulbs - its not unusual for both bulbs to blow at the same time.

Reply to
Rob

Could be loose wire? check all the wires and the fitting at the lights even the earths as some times if they are not tight they can play around with your lights etc..

Reply to
Chris

I drive an 03 diesel version and its the 3 spades in the plastic moulding which plug into the bulb that goes open circuit from corrosion every year or so.

posting from d-i-y

AJH

Reply to
andrew

Need to spray wd40 all over it that stops it.

Reply to
Chris

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.