1. Home
  2. Mazda Miata
  3. Factory alignment specs

Factory alignment specs

At

formatting link
the following is given as the factory alignment specs: FRONT Caster +4.43 +/- 0.75 Camber 0.4 +/- 0.75 Toe 1/8" +/- 1/8

REAR Caster not applicable, there is no adjustment possible Camber -0.72 +/- 0.5 Toe 1/8" +/- 1/8"

Can anyone verify if these are correct? Specifically the front camber (seems like it should be -0.4 +/- 0.75). I ask because to race in the stock class in Solo II I'm required to remain within the factory alignment specs.

Jules d'Entremont

Reply to
Jules d'Entremont
Loading thread data ...

From my 1994 shop manual (other years may be different); converted from degrees and minutes:

FRONT Total toe: 0.12" +/-0.12" Camber: depends on ride height, but varies from -1.0833 to +1.7833 including tolerance Caster: depends on ride height, but varies from 3.6 to 6.0167 including tolerance

REAR Total toe: 0.12" +/-0.12" Camber: depends on ride height, but including tolerance varies from 0 to

1.6333

All measurements taken with full fuel tank and spare tire, jack, and tools in specified positions. Give me your ride height (center of hub to fender lip) and I'll post back the exact spec.

Note that front toe out is not permitted!

Reply to
Lanny Chambers

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.