1994 Pathfinder keyless entry code

I am looking for directions to reset my keyless entry transmitters for the Pathfinder. Does any one know the procedure or know where I can get them. Thanks! Bill

Reply to
Carbon Man
Loading thread data ...

search the newsgroup, it has been answered numerous times

Reply to
NissTech

Reply to
ron

You bought the directions on eBay? How much did you pay? Are they the same as these?

To enter the ID code, follow this procedure.

Entering "Setting mode": (1) Close and lock all doors.

(2) Insert and remove the key from the ignition more than six times within 10 seconds. (The hazard warning lamp will then flash twice.) At this time, the original ID codes are eliminated.

ID code entry: (3) Turn ignition key to "ACC" position.

(4) Push lock button on the new remote controller once (for example, if door is locked using the remote controller during this ID code entry enable state, a new ID code can be entered). At this time, the new ID code is entered. (The hazard warning lamp will then flash twice.)

Additional ID code entry (5) If you need to activate additional remote controllers, unlock the driver's door, then lock again with door lock knob.

(6) Push lock button on the additional new remote controller once.

(7) This ID code entry enable state and setting mode remain until the driver's door is opened.

NOTE If you need to activate more than two additional new remote controllers, repeat the procedure "Additional ID code entry" for each new remote controller. If the same ID code that exists in the memory is input, the hazard warning lamps will flash twice but the entry will be ignored. Entry of maximum four ID codes is allowed and any attempt to enter more will be ignored. Any ID codes entered after termination of the "setting mode" will not be accepted. Additionally remote control signals will be inhibited when an ID code has not been entered during the "setting" mode.

Reply to
Bill Schnakenberg

Hi,

94 pathfinders are different than the newer ones. They have a control box located under the drivers side seat for the alarm. It is easier if you remove the seat if you don't know where to find it. Look for a small black box with a white label over it. In the center of the label there will either be a circle hole poked through it or it will feel hallow under the label.. look into the circle hole and you will see a yellow square button..Make sure the key is not in the ignition. Push the button in and hold it for a few seconds you will here a series of beeps. press the lock button on the remote once then turn the ignition key on to stop the programming process..

Hope this helps.

Mark I - Nissan Tech

Reply to
Mark Iezzi

You sure those work on the PF? My 95 PF required pushing and holding a button under the seat.

Reply to
Chuck Tribolet

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.