heres the wireing diagrams
| 12V| | green | | + | ignition harness | | STARTER | | black/red or blk/wht | | + | ignition harness | | SECOND STARTER| | black/blue | | + | ignition harness | | IGNITION| | black/red (smaller) | | + | ignition harness | | ACCESSORY| | red/yellow | | + | ignition harness | | SECOND ACCESSORY| | white/blue | | + | ignition harness | | POWER LOCK| | gray | | - | pin 23 at SECU *1 | | POWER UNLOCK| | brown/yel | | - | pin 35 at SECU *1 | | LOCK MOTOR| | purple | | | pin 15 at SECU *1 | | UNLOCK MOTOR| | white/black | | | pin 13 at SECU *1 | | DISARM DEFEAT| | green/yellow | | | pin 14 at SECU *1 | | PARKING LIGHTS +| | red/blue | | | driver kick panel *2 | | PARKING LIGHTS -| | lt. blue | | | headlight switch | | HEADLIGHTS| | pink | | - | headlight relay *7 | | DOOR TRIGGER| | *3 | | | SECU *1 | | DOME SUPERVISION| | use door trigger | | | | | TRUNK/HATCH PIN| | purple/yellow | | - | pin 38 at SECU *1 |
NOTE: This vehicle has an immobilizer system that needs to be bypassed during remote start operation. *1 The SECU (Smart Entrance Control Unit) is located to the passengers side of the steering column
*2 Can also find red/green or red/yellow at fuse box
ok
What I am trying to do is set it up so that I can start the motor with a push button switch. Let me go more into detail You put the key into the ignition and you turn it to run ( notice I said run not start) then you push this button and the motor starts.
So here's what I did
I hooked up to the secondary accessory line so the car is only startable when the key is in the starter. Put a 12v fuse in there for protection. Then the switch it was rated for 12v and was labeled for push button ignition so I didn't feel I needed to use a relay. Then I wired to the starter line. Tried it and nothing. So I tied together both starter lines and still nothing. I grabbed the manual checked what points had continuity between them on the leads on the ignition module. There was continuity between the
12v, starter1, starter2, and ignition. So then I grabbed power from the 12v and wire the push button switch to starter 1, 2, and ignition. After I reconnected the battery I tried it once again and nothing happened. So I'm out of ideas. Does and one have an idea ?
Thanks snipped-for-privacy@earthlink.net