Automotive Technologies

  1. Home
  2. Automotive Technologies
15187 Threads Posts
to

Worth reading in Automotive Technologies

1991 Ford Festiva Running and Dash light problem

Everything works fine but the running lights (including tail lights) and the dash lights (but the idiot lights work and...
0 comments posted 23yrs
posted by benhogland
0 comments posted 23yrs posted by benhogland

noise first time brakes are applied in fwd/reverse

I replaced my front pads and rotors on my 93 Cutlass Supreme a couple weeks ago. (I used some stuff on the back of the...
3 comments posted 23yrs
posted by sasakand
3 comments posted 23yrs posted by sasakand

O-scope square waveform interpretation?

I recently scoped the Hall-Effect sensor on my 91 Saab 900 (4 cyl, electronic ignition w/one coil, distrib, rotor), whi...
5 comments posted 23yrs
posted by alancemor
5 comments posted 23yrs posted by alancemor

siezed bolts/nuts how to remove??

Hi Last night I "planned" on replacing the outer tie rods on my van. I've posted previously about this yesterday. Anywa...
8 comments posted 23yrs
posted by ortho
8 comments posted 23yrs posted by ortho

Odd timing question

I recently purchased a 1970 vette w/ 350 small block. The spec manual say to set the timing at 6 deg BDC. However in or...
3 comments posted 23yrs
posted by postings
3 comments posted 23yrs posted by postings

Mazda 626 stutters around 1700 rpm

Hi, I have a 1998 Mazda 626, LXi 2.0, 150k miles, always serviced at Mazda garages. It started to stall and stutter rec...
2 comments posted 23yrs
posted by ayoshak
2 comments posted 23yrs posted by ayoshak

shell diagrams available?

Hi, I'm looking for those diagrams, indicating fuel efficiency over torque and reversions, for engines of any type. Unf...
0 comments posted 23yrs
posted by thomas.schaefer
0 comments posted 23yrs posted by thomas.schaefer

1996 chevy blazer service manual

Does anyone know where I can purchase a service (shop) manual for my son's 1996 chevy blazer 4.3? I tried ebay, etc with...
3 comments posted 23yrs
posted by hakone
3 comments posted 23yrs posted by hakone

Stalling Mazda B2200

Hi, I ran out of gas in my '87 B2200 (when I tried to accelerate engine quit). After refuelling the engine does not shu...
8 comments posted 23yrs
posted by cplassREMOVE
8 comments posted 23yrs posted by cplassREMOVE

geo metro flasher relay

Hi, Can anyone tell me where the Flasher is located on a 1994 Geo Metro? Although all the fuses and bulbs are good, sig...
0 comments posted 23yrs
posted by astro304
0 comments posted 23yrs posted by astro304

Re: How can I clean a catalytic converter?

> > > > > If I have a used catalytic converter, is there any way I could > > chemically or physically clean it. > > No....
6 comments posted 23yrs
posted by No_Spam
6 comments posted 23yrs posted by No_Spam