Bell housing and engine removal

Wanted to pull the engine on my 71 bus today to fit a new clutch kit. Removed cross member and 2 bolts on the bell housing, engine won´t come out. Someone told me there are 2 more, where, and how to access them? Inside engine compartment or outside under the car?

Bart Bervoets

Reply to
Bart Bervoets
Loading thread data ...

One is the bolt that goes thru the starter motor flange. Gotta remove the 17mm nut from the engine side. Other is a bolt that goes thru the bellhousing just above the clutch lever. Your engine might have a 17mm nut on the engine side. Be sure the engine is well-supported...

Speedy Jim

formatting link

Reply to
Speedy Jim

Reply to
ilambert

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.