> Hey everyone. I recently ordered a front disc brake kit from
> Aircooled.net. The kit I got was the one for FOUR lug, balljoint
> front end, at stock ride height. (cheapest one at just about $300) It
> will be here soon, and I'm considering all the possible problems I
> could run into putting them on. I hear they are fairly easy to
> install, work great, and have been assured they are of very high
> quality. Does anyone have any advice for this project? Has anyone
> worked with this kit before? I will apreciate any help. The thing
> I'm most concerned with is removing the old spindle and putting the
> new one on. I hear alot about using a pickle fork, but I also hear
> that this method can damage your balljoints and or rubber seals. > What's the deal?
> Thanks again.
That's right; the pickle fork is not the appropriate tool. You need the "lever-action" ball joint tool. Pic here:
formatting link
Even with the tool, removal can be tough. Apply full force with the tool, then give the side of the spindle a healthy whack with hammer. Should hear a loud explosion noise as the stud pops out.
Speedy Jim
formatting link