Hello all,
I am trying to remove the brake light switch above the steering column of a '98 Suburban and cannot figure out how to get the retaining clip off.
Any idea?
TIA,
Raybo
Hello all,
I am trying to remove the brake light switch above the steering column of a '98 Suburban and cannot figure out how to get the retaining clip off.
Any idea?
TIA,
Raybo
Removal Procedure
For information on stoplamp circuit diagnosis, refer to Lighting Systems in Body and Chassis; and Electrical Diagnosis.
Caution
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components. 1. Disconnect the negative battery cable. 2. Disable the SIR. Refer to Disabling the SIR System in SIR. 3. Remove the pushrod retainer from the brake pedal pin. Use snap ring pliers. 4. Unsnap the stoplamp switch from the pushrod. 5. Disconnect the electrical connector from the stoplamp switch.
Installation Procedure
screwdriver and/or cotter pin puller.
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.