Jeep and Willys (new and old)

14215 Threads Posts
to

Cherokee turn sig lamp socket source?

Need replacement sockets for right front turn signal, not the lens, but the bulb holder. Even though this socket has a...
6 comments posted 22yrs
posted by gcooper
6 comments posted 22yrs posted by gcooper

Trails/ORV Parks

Has anyone been on the trails of Wind Rock in TN? I frequent Tellico outside of Murphy, NC and have been to Grey Rock o...
2 comments posted 22yrs
posted by bryan.shaver
2 comments posted 22yrs posted by bryan.shaver

Distributor problem

I got a problem that has been kickin my a## for awhile. I replace my stock distributor on my 258 with a HEI, the origin...
7 comments posted 22yrs
posted by footloose61
7 comments posted 22yrs posted by footloose61

Fiberglass Bikini Top

Has anyone ever heard of or built a fiberglass bikini top? The molded bikini by bestop comes close to being what I want...
0 comments posted 22yrs
posted by leehoffman
0 comments posted 22yrs posted by leehoffman

Bill and Jerry: I finally broke my Dana35

About a year ago I got into a thread with Bill and Jerry about wheelin' a D35 with 35s and a locker. They both assured...
9 comments posted 22yrs
posted by jp4by4cya
9 comments posted 22yrs posted by jp4by4cya

How many pistons do you have?

Here's a funny topic taken from a Jeepster newsgroup. How many pistons do you have at your place, running or not? My co...
23 comments posted 22yrs
posted by spam
23 comments posted 22yrs posted by spam

Jeep Liberty

Does anyone have any idea who might be able to reprogram the on board computer to change features? TIA KEN
0 comments posted 22yrs
posted by asken
0 comments posted 22yrs posted by asken

90 YJ Filling Axle Sift Motor Housing

Ok, The factory service manual for my 90 YJ clearly says page 2-59 that when you install the axle shift motor housing f...
4 comments posted 22yrs
posted by mvincenty
4 comments posted 22yrs posted by mvincenty

Dana 30 pinion shaft play

There should be no lateral play (up-down, left-right) in the pinion shaft of a Dana 30, should there? :-/ --
5 comments posted 22yrs
posted by matt
5 comments posted 22yrs posted by matt

Onboard air question

I have a Truck/Rv 250-psi Cordless Air Compressor and would like to know if this would be OK to use as a compressor for...
5 comments posted 22yrs
posted by snowboardripper
5 comments posted 22yrs posted by snowboardripper

Back in the Saddle

It's been 4.5 long years since my CJ-7 went down the road in someone else's hands. As of Sunday, I'm finally back in a...
3 comments posted 22yrs
posted by SpamFree
3 comments posted 22yrs posted by SpamFree

when does 'flippage' begin?

I seem to remember a lot of talk a few years back about Jeeps flipping over going up hills. I think the worst for this...
17 comments posted 22yrs
posted by dmpazlee
17 comments posted 22yrs posted by dmpazlee