Hi all, I'm looking at changing the drivers side front wing on a Fiesta. It's a 93 model and the wing looks like it's spot welded on rather than a bolt on type. Are they easy to replace or is it a job for a body shop? Cheers.
Easy enough if you have a drill and can use a MIG welder. Drill out the spot welds and remove the wing. Drill holes in the new wing in roughly the same places as the original spotwelds. Fit the new wing, using PK screws if necessary to hold it in the correct position. When you're satisfied, MIG weld in the pre-drilled holes, making sure the wing is tight up to the inner wing etc. Take the screws out and weld those holes as well. Clean up the welds in the gutter with an angle grinder. Use seam filler to seal any gaps, and u/seal the join and any exposed holes under the wing, to stop water getting into the joint. Paint to match, job done. Mike.
MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.