Jubilee clips

May 14, 2006 4 Replies

Whilst removing the intake manifold on a 205 GTi, I noticed the abundance of types of hose clip. Given previous owners tendencies to bodge these cars, I am curious to know what the correct fittings are.



I have noticed 7mm nut types, and a type with no nut that I have no idea how to fit or remove. Are these interchangeable? How do I fit and remove the latter type?



If the parts diagram doesn't show a clip, can I assume that a clip isn't needed? For example, lots of oil breather hoses have a clip on my car (usually in an awful place to undo), but on the parts diagram, there is no clip.


These latter are once-only, fitted at the factory. You have to cut them off and replace with adjusrable ones.

Dunno. Ther answer may depend on where and what car. I would imagine that, in general, hoses need clips. But there may be instances where there is little or no pressure and the hose will remain in place without a clip.

Rob Graham

Things like vacuum hoses often don't have clips. Which is fine 'till the rubber hardens slightly.

Are you saying that it is worth putting clips where there were none? I remember a discussion on Jagforums that clips could be worse than none in some cases, although perhaps this related to some fuel lines that were designed to be clip-less.

Interesting, i wonder how come clipped could be worse than non. Apart from a badly applied one crushing something.

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required