I've misplaced my Haynes manual and noticed that one rear wheel bearing of t'wife's Mondeo estate (W reg Mk2) has way too much play. Anyone know if these are straighforward to replace (or tighten up?) without a manual, or should I turn the garage upside down trying to find that damned thing?

Nothing too hard. The wheel bearing comes as a complete hub assembly so=20nowt to press in or out. Needs a 32mm socket for the hub nut.=A337.89 inc delivery:ConorI only please one person per day. Today is not your day. Tomorrow isn't=20looking good either. - Scott Adams

Mondeo rear wheel bearing - easy?

Jun 24, 2009 21 Replies

Rate this thread:

PCPaul 17 years ago

Yep, those were for a Mark 1. And for the Mk.1 Estate (with a drum handbrake *and* a disc footbrake on it...) those bolts had 65Nm/48lb.ft listed.

Vote

Harry Bloomfield 16 years ago

Conor presented the following explanation :

Did I hear that tightening and undoing needs a massive amount of torque on that nut?

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required