I've got a new Clifford g5 alarm manual is for us consumers not uk.
I would like to no the best way to wire it up so that it protects the cab and the back of the van.
can someone tell where to connect some wire?
violet (+) door trigger input - connect this to a wire that shows (+) 12v when any door is open.
Green (-) door trigger input - most vehicles use negative door trigger circuits. connect this wire to a wire showing ground when any door is open.
White/red light flash input - this wire is the input for the on-board dual light flash relay. if the vehicle has positive parking light activation wires, connect this wire to a constant (+) 12v source that is fused at 15a or higher (if the vehicle parking light activation wire is negative, connect this wire to a chassis ground.
white parking light output - these wires are output of an on-board dual make relay and should be connected to wires in the vehicle that control the parking light wire polarity. if the vehicle's parking lights are controlled by a single wire connect both white wires.
thanks for the help.