Remote starters.

I don't know for certain, but I can offer an educated guess - it should be the same as far as the ignition and sensor wiring that you'd be tying into.

Lane [ l a n e @ p a i r . c o m ]

heheh, just make sure you don't bypass the gearshift interlock. or clutch one. It's never fun to hit the button and watch your car start up and drive off, though if you're an onlooker it's quite funny...

OK called the company and they told me it's the same>

Next question is

When I attach the wires for the remote start do I splice the wires in? or do I cut and replace?

Ummmm.....

If you don't bypass the clutch switch, how is the car going to start without you pushing the clutch in?

Considering it's a '91 maybe that is the idea remote start off a cliff for the insurance.

Uh guys I have an automatic and being a 91 its a good car.. and very dependible.

any ways, I have to wait to do this.. looks like I may need almost a half a day,

My '93 isn't that far off - I'm sick of being nickle and dimed to death by it. I swear, it's the mythical car built so perfectly EVERY part fails at the same time...

Apparently, 220,000 miles is it's time, too :/

I hope you:

1) received installation instructions 2) have a set of factory service manuals, or at least a Haynes/Chilton manual 2) have more than half a day

Realistically, this stuff always takes much more time than expected for the do-it-yourselfer. But I find that that brings a lot of satisfaction with it too.

Lane [ l a n e @ p a i r . c o m ]

1: Got the install Instructions, with the diagram! CHECK 2: Haynes manual CHECK 3: half or maor day... Planning that one out.

Question for you LANE I seen in your Ebay auction that shipping is from

54481 Where about do you live? I live off of Green ave. near the airport right off of HWY 66