Trunk seal

- J
- John Poulos
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Wed, Jul 18, 2007 4:14 AM

All the WS instructions are in the SI catalog.

Pat Dill> I have a new trunk seal for my 53 Coupe that I got from Studebaker

- P
- Pat Dilling
  
  Contact options for registered users
posted
16 years ago

Wed, Jul 18, 2007 4:15 AM

I have a new trunk seal for my 53 Coupe that I got from Studebaker International. The seal that was in there is a generic one I think, since it was cut at the corners. The new one has a flat side with a flap and a grooved side. There were no instructions, which side goes up? Any tips or hints for the install? I have the old one out and am in the process of cleaning the residue before installing the new one.

thanks in advance

Pat

- P
- Pat Dilling
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Wed, Jul 18, 2007 4:41 AM

Thanks John,

Found 'em, shoulda looked there first.

Pat

- J
- Judy Sauer
  
  Contact options for registered users
Vote on answer
posted
16 years ago

Wed, Jul 18, 2007 4:45 AM

I have a question about the trunk seal as well. The instruction (for the Hawk) sez that the 'legs' are glued into the channel, with the 'wing' pointing *away* from the body. Maybe I think too much, but that could be taken either way - which is correct - pointing in the direction of the fin, or pointing in the direction of the trunk? or does it matter? Not that I will necessarily rip it out and redo it, if I've misinterpreted the instruction.......

j

John Poulos wrote: