Automotive Technologies

15186 Threads Posts
to

Bosch Windshield Adapter Concern

I recently purchased two sets of the Bosch Micro Edge windshield wiper blades. I became concerned during installation w...
0 comments posted 22yrs
posted by InfoQuest
0 comments posted 22yrs posted by InfoQuest

stablizer bar question

Hayne's manual says to not tighten the stabilizer bar retaining bolts (two on left, two on right) until after I put the...
3 comments posted 22yrs
posted by rowest
3 comments posted 22yrs posted by rowest

'96 Taurus dome light stays on.

My mom's '96 Taurus has had her dome light stay on longer and longer. It used to go off by itself, but then started sta...
0 comments posted 22yrs
posted by kruse
0 comments posted 22yrs posted by kruse

Questions about Grille inserts.

I've always wanted to use them because we get alot of gravel dumped on the roads during the winters and have already fo...
4 comments posted 22yrs
posted by no
4 comments posted 22yrs posted by no

ceramic brake pads & warped rotors

Anyone else experiencing reoccuring warped rotors after installing ceramic brake pads? My father did complete brake job...
1 comments posted 22yrs
posted by cadaman
1 comments posted 22yrs posted by cadaman

5th Ave Problems

Hi I have a 1990 Chrysler New Yorker when I drive for a few miles it really jerks a lot real scarey like it's not getti...
0 comments posted 22yrs
posted by maryemar2001
0 comments posted 22yrs posted by maryemar2001

88-90 GM 3800 V6 Balance Shaft help

What's to pulling and reinstalling this balance shaft? A special tool is mentioned in the manual, but is it necessary? A...
6 comments posted 22yrs
posted by Sorry
6 comments posted 22yrs posted by Sorry

89 Caprice still funky

A couple days ago I mentioned the problem I've been having with my usually reliable 89 Caprice-- after it goes around t...
4 comments posted 22yrs
posted by pbwriter1
4 comments posted 22yrs posted by pbwriter1

Mazda MPV factory security system connector

Has anyone seen a pinout for the Mazda MPV factory security system connector? It's supposed to have wires for door locks...
0 comments posted 22yrs
posted by right2trash
0 comments posted 22yrs posted by right2trash

Choke Heat Device? Ford 460

I just bolted a new Holley 4160 (80508) on my 78 Lincoln Mark V. Vacuum hoses reconnected fine, but there are still 2 s...
2 comments posted 22yrs
posted by aceshigh24450
2 comments posted 22yrs posted by aceshigh24450

Gasoline pumped to diesel tank......

I have diesel engine Volvo Penta MD3 on my sailboat.Just after refueling in one of the marina (in 10 minutes) engine re...
3 comments posted 22yrs
posted by katskradle
3 comments posted 22yrs posted by katskradle

ALTAMONT PASS WINDMILL BIRDS DEATHS

ALTAMONT PASS WINDMILL BIRDS DEATHS the dam birds need to get glasses or stop flying drunk.
0 comments posted 22yrs
posted by BIRDSGETGLASSES
0 comments posted 22yrs posted by BIRDSGETGLASSES

flasher unit ICs.

OK, so I've got these LED lamps, and now the indicators (flashers) don't work right. So I fitted load resistors short-t...
0 comments posted 22yrs
posted by austin
0 comments posted 22yrs posted by austin

Re: Put in new head and now rpm will not go high.

There are a couple of things that are the most often offenders when this sort of job is done, Tibur. When a distributor...
1 comments posted 22yrs
posted by larrys25
1 comments posted 22yrs posted by larrys25