Entering radio code

Hi,

I have just had to replace the battery in my Renault Laguna RT 1.8 and need to re-enter the code for my Renault/Pioneer CD/radio. I have the code and remember that I use the first 4 preset channel buttons to cycle through and set each number of the 4 digit code in turn. However, after I have setup the number I can't get it to accept the entered code. Any clues greatfully accepted.

Reply to
Ukky
Loading thread data ...

are you pressing preset 6 to 'enter' the code?

Reply to
mrcheerful

Yes that is one of the things I did in a "lets just push any button" fit

- It gives a single beep and then re-displays "CODE".

Reply to
Ukky

If it shows code relentlessly, then you need to leave it turned on for two hours then try again, apparently.

Mrcheerful

Reply to
mrcheerful

A bit late now, but if you connect another battery via jump leads to the battery leads before you remove them from the duff battery, put the new battery in place, connect the leads and remove the jump leads, you don't ever have a disconnection and so don't need to recode the radio.

Rob Graham

Reply to
Rob graham

On my Laguna, the tuning wheel (on s/wheel radio stalk) selects the numbers to enter, then button on that stalk confirms, after the 4th hold same button for about 30sec to complete the process. Radio comes on. Lol

Reply to
Lol

MotorsForum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.